Factory Cheap Hot Toshiba IS550GS (V21 PLC) used Injection Molding Machine Supply to Jordan

Toshiba 550t Used Plastic Injection Molding Machine

Youtube Video: https://youtu.be/UitwA3h4ajo

Model: IS550GS-34A
Tie bar spacing: 860x860mm
Screw diameter: 80mm
Year: 2006
Controller type: V21

Machines are in good working condition. Our warehouse is located at ShenZhen of China, very near HongKong and GuangZhou. Interested buyers are welcome to visit our warehouse during Chinaplas to inspect and test run machines.

Product Image

This is a video of the Egg Carton manufacturing equipment at work. It uses scrap paper as raw material.

Electric motor Armature repair, NEVER TRY THIS EVER! Electricity can and will kill you if your are not careful, if you have a bad armature, replace it, do not try to repair it, this only shows you the mechanics of an armature and this probably won't last long. I ended up using a brass brush instead, the copper did not last long, and don't forget to clean your graphite brushes with light sanding. I also put a heat resistant ring around both ends of the armature brushes cut out of tubing and glued them in, this worked good at holding the brush in place. Any time you experiment with motors they can hold a spark for a long time after you are done so make sure you watch your project for a while after to prevent any fire hazard. Again don't ever do this just replace the armature with a brand new one, or better yet get a new tool. The cost for a new tool is similar to an armature cost, this is desert island science, for those people stranded on an island with nothing but spare parts. keep inventing'