Good quality Toshiba IS1050GT Injection Molding Machine to Sudan Manufacturers

Product Detail

Product Tags

Feedback (2)

To consistently enhance the management method by virtue of the rule of "sincerely, fantastic religion and top quality are the base of business development", we extensively absorb the essence of associated goods internationally, and constantly acquire new merchandise to satisfy the needs of shoppers for LG Plastic Machine , China Injection Machine , Servo Injection Molding Machine , We would like to take this opportunity to establish long-term business relationships with clients from all over the world.

Good quality Toshiba IS1050GT Injection Molding Machine to Sudan Manufacturers Detail:

Toshiba 1050t used plastic injection molding machine.

Model: IS1050GT.

Year of manufacture: 2004.

Tie bar spacing: 1280x1280mm.

Screw diameter: 115mm.

Machine is in very good condition. Interested customer is welcome to inspect and test run machine before placing any order.

Product Image

Product detail pictures:

The key to our success is "Good Product Quality, Reasonable Value and Efficient Service" for Good quality Toshiba IS1050GT Injection Molding Machine to Sudan Manufacturers, The product will supply to all over the world, such as: Vietnam , Grenada , Namibia , Our company follows laws and international practice. We promise to be responsible for friends, customers and all partners. We would like to establish a long-term relationship and friendship with every customer from all over the world on the basis of mutual benefits. We warmly welcome all old and new customers to visit our company to negotiate business.

Electric motor Armature repair, NEVER TRY THIS EVER! Electricity can and will kill you if your are not careful, if you have a bad armature, replace it, do not try to repair it, this only shows you the mechanics of an armature and this probably won't last long. I ended up using a brass brush instead, the copper did not last long, and don't forget to clean your graphite brushes with light sanding. I also put a heat resistant ring around both ends of the armature brushes cut out of tubing and glued them in, this worked good at holding the brush in place. Any time you experiment with motors they can hold a spark for a long time after you are done so make sure you watch your project for a while after to prevent any fire hazard. Again don't ever do this just replace the armature with a brand new one, or better yet get a new tool. The cost for a new tool is similar to an armature cost, this is desert island science, for those people stranded on an island with nothing but spare parts. keep inventing'