OEM Manufacturer Niigata 280t All-Electric used Injection Molding Machine for Mexico Importers

Product Detail

Product Tags

Feedback (2)

The purchaser fulfillment is our primary focus on. We uphold a consistent level of professionalism, high quality, credibility and service for Haitian Injection Machine , Sumitomo Used Plastic Machine , CLF , Our products are widely recognized and trusted by users and can meet continuously developing economic and social needs.

OEM Manufacturer Niigata 280t All-Electric used Injection Molding Machine for Mexico Importers Detail:

Niigata 280t all-electric used Injection Molding Machine

Youtube Video: https://youtu.be/8V2Loj9puxI

Model: MD280S-IV.

Year: 2006.

Screw diameter: 52mm.

Tie bar spacing: 620x620mm.

Injection Speed: 300mm/s.

Machine is in good running condition. You can always visit our warehouse to inspect it and test it running.

Daxin Machinery

-Over 200 units of used injection molding machines in stock
-All can be inspected in the same warehouse under one roof
-All can be powered on for test-run in working condition

sales@daxin88.com / daxin88@hotmail.com
Skype: daxin-machinery / www.daxin88.com
Mobile: +8613509620296 (whatsapp) / +6596479097 (WeChat)
Follow Daxin Machinery: Facebook, Twitter, Google+, LinkedIn, Youtube.

Product Image

Product detail pictures:

Our well-equipped facilities and great excellent command throughout all stages of generation enables us to guarantee total customer fulfillment for OEM Manufacturer Niigata 280t All-Electric used Injection Molding Machine for Mexico Importers, The product will supply to all over the world, such as: Serbia , Haiti , Gambia , We adopted technique and quality system management, based on "customer orientated, reputation first, mutual benefit, develop with joint efforts", welcome friends to communicate and cooperate from all over the world.

Electric motor Armature repair, NEVER TRY THIS EVER! Electricity can and will kill you if your are not careful, if you have a bad armature, replace it, do not try to repair it, this only shows you the mechanics of an armature and this probably won't last long. I ended up using a brass brush instead, the copper did not last long, and don't forget to clean your graphite brushes with light sanding. I also put a heat resistant ring around both ends of the armature brushes cut out of tubing and glued them in, this worked good at holding the brush in place. Any time you experiment with motors they can hold a spark for a long time after you are done so make sure you watch your project for a while after to prevent any fire hazard. Again don't ever do this just replace the armature with a brand new one, or better yet get a new tool. The cost for a new tool is similar to an armature cost, this is desert island science, for those people stranded on an island with nothing but spare parts. keep inventing'